Descargar Imprimir esta página

Caring For Your Steam Pocket Mop - Shark KLIK N' FLIP S6001EU Manual De Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
Caring for Your Steam Pocket
fig. 12
AFTER USE AND STORAGE
1
Unplug the cord from the outlet and place the Steam
Mop into the upright position. Let it cool.
2
To remove the Dirt Grip
straight up by the handle until the Klik N' Flip Mop
Head is hanging straight down. Press the Release
button on the back of the Steam Mop body, and both
sides of the Klik N' Flip Mop Head will drop open,
releasing the pad. Once the pad has been released,
close the Klik N' Flip Mop Head.
3
If the Klik N' Flip Mop Head is not attached to the
Steam Mop, the pad can still be removed. Press the
two red secondary pad release buttons located on the
sides of the Klik N' Flip Mop Head post to release the
pad. (fig. 12)
4
Empty the water tank before storing. To empty the
tank, hold the Steam Mop beside a sink. Open the
water tank lid, then lean the unit over the sink. Let
the water drain out, then close the lid.
5
To store the Steam Mop, wait until after it has cooled
and the steam has been released. Then remove the
Klik N' Flip Mop Head and hang the Steam Mop by its
handle on a large hook (not included). (fig. 13)
6
Store the filling flask by attaching it to the top handle
pole of the Steam Mop.
34
®
fig. 13
pad, lift the Steam Mop
Mop
fig. 14
DIRT GRIP PAD CARE INSTRUCTIONS
Care
Machine-wash the Dirt Grip pads separately with warm
water using liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT, OR
FABRIC SOFTENERS as they may damage or leave
a coating on the Dirt Grip pads that will reduce their
cleaning performance and absorbency. Dirt Grip pads
should be line-dried or tumble-dried on a low setting, as
this will extend the life of the microfiber fabric. (fig. 14)
Loose fibers can indicate wearing of the microfiber
fabric. Do not pull the loose fibers, as this can cause the
weave to come undone. Simply trim the loose fibers with
scissors. (fig. 15)
Replacement Dirt Grip pads
For best cleaning results, we recommend replacing your
Dirt Grip pads every 3 to 4 months following normal use.
As with any fabric, dirt particles, grease, friction, and
repeated washing can cause the fibers to break down,
and you may notice an increase in the effort needed to
push or pull the Steam Mop.
You can purchase replacement Dirt Grip pads and other
accessories by visiting sharkclean.eu.
STEAM NOZZLE CARE
If you believe the main steam nozzle or the Steam
Blaster
nozzle is clogged, please contact Customer
Service at www.sharkclean.eu
fig. 15

Publicidad

loading