Publicidad
Idiomas disponibles
Idiomas disponibles
2. WHEN THE AIR CONDITIONER IS RUNNIG
If you want to turn off the air conditioner, switch the OPERATION
SELECTOR TO the OFF position.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
EG
OFF
TEST
ON
OPR STANDBY
TIMER
OPERATION
SELECTOR
CARE AND CLEANING
WARNING
●
For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
●
Do not pour water on the indoor unit to clean it. This will damage
the internal components and cause an electric shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent.
When cleaning the grille, be careful not to force the vanes out of
place.
CAUTION
●
Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
●
Some metal edges and the vanes are sharp and may cause
injury if handled improperly; be especially careful when you
clean these parts.
●
The internal coil and other components of the outdoor unit must
be cleaned every year. Consult your dealer or service centre.
AIR FILTER
The air filter behind the air intake grille should be checked and
cleaned at least once every two weeks.
HOW TO REMOVE THE FILTER
1
1. Move the flap on the air outlet grille to the vertical position with
the remote control unit.
2. The filter is disengaged by pushing the tab up gently.
3. Hold the air filter by the tab at the bottom, and pull downward.
Clean the air filter.
4. When replacing the filter, make sure that the FRONT mark is
facing you. Push it up until you hear it click back into position.
OFF
TEST
OPERATION
SELECTOR
2
4
3
HOW TO REMOVE THE FILTER
1
2
1. Grasp both ends of the air intake grille and pull to open it.
2. Hold the air filter by the tab and pull it upward. Clean the air
filter.
3. When replacing the filter, make sure that the FRONT mark is
facing you. Reinsert the filter into place and close the air intake
grille.
ON
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soapy water, rinse it
in clean water, and dry it.
"AIR CLEAN" FILTER (KPAxxx MODEL)
(ACCESSORY SUPPLIED ON REQUEST)
●
The air filter is to be added by springs to the standard filter.
●
It is made of two layers:
- the first layer consists in a synthetic honey comb high efficiency
media to remove the dust and purifing the air.
- the second layer in charcoal media deodorizing the ambient
air.
How to install the "Air clean" filter.
1. Open the unit intake air grille and pull out the standard air
filter.
2. Apply on the rear side of the filter the two spings supplied with
the accessory.
3. Fix the "air clean" filter by the springs.
4. Insert the two air filters one over the other and close the intake
grille.
REAR SIDE OF
ANTI-MOLD FILTER
"AIR CLEAN" FILTER
(HIGH EFFICIENCY
HONEYCOMB AND
CHARCOAL MEDIA)
ACCESSORY ORNAMENTAL TAPE (KPAxxx MODEL)
Included with the air conditioner is red and green ornamental tape
which can be used for decorative trim instead of the gray tape
which was applied at the factory.
Depending on the room color scheme, apply one on the alternative
colored tapes as trim if it is more suitable than the standard gray.
To apply, align the tape along the edge of the unit and cut to fit.
10
3
SPRING
TAPE POSITION
SELECT THE MOST SUITABLE TAPE COLOR
Publicidad
