Publicidad
Idiomas disponibles
Idiomas disponibles
23
⁄
"
3
4
(603 mm)
11
⁄
"
7
(8.8 mm)
8
(302 mm)
Step 3: Attach the Overlay Panel to the Drawer
1. Set the overlay panel on drawer front face and align
edges. (See Figure 19). The custom overlay panel
should be flush with the top of the drawer and centered
on the width of the drawer. Clamp panel in position and
mark pilot hole locations. Pick the required pilot hole
size from "Table A" below and drill the pilot holes ensur-
ing not to drill all the way through the overlay panel.
Table A: Pilot Hole Drill Sizes for Wood Screws
Material Type
Hardwood
Softwood
2. Insert wood screws through clearance holes and
tighten to secure overlay panel.
3. Reinstall gasket into channel. Make sure the corners
are fully inserted.
4. Place the drawer divider back into the drawer.
OVERLAY DRAWER PANEL INSTALLATION
Panel
thickness
14
⁄
"
29
32
(379 mm)
⁄
"
11
32
Figure 18
⁄
" (12.7 mm)
1
2
diameter, top
drawer only
#8 Wood Screw
⁄
Diameter Pilot Hole
1
8
⁄
Diameter Pilot Hole
7
64
Figure 19
1"(25 mm) diameter counter
bore
⁄
" (6 mm) deep
1
4
2 places, top drawer only.
2
⁄
"
3
8
(60 mm)
This side
facing interior
15
19"
(483 mm)
1
⁄
"
3
16
(30 mm)
⁄
" (21 mm)
13
16
counterbore
⁄
" (12 mm)
7
16
deep, top
drawer only
Screw clearance
hole through
gasket extrusion
Figure 19a
Overlay panel
flush with top
edge of drawer
Custom overlay
panel to be cen-
tered on width of
drawer.
Using clearance holes in
gasket channel mark
hole locations onto panel
Publicidad
