Power Supply Cord
NOTE: Your air conditioner's device may differ from the one
shown.
A. Test button
B. Reset button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense current leakage. If the cord is crushed, the
electronics detect current leakage and power will be disconnected
in a fraction of a second.
Unpack the Air Conditioner
Remove Packaging Materials
Remove and dispose of/recycle packaging materials. Remove tape
and glue residue from surfaces before turning on the air
conditioner. Rub a small amount of liquid dish soap over the
products can damage the surface of your air conditioner.
Handle the air conditioner gently.
All manuals and user guides at all-guides.com
A
B
INSTALLATION INSTRUCTIONS
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for click; Reset button will trip, and on
some devices, a green light will turn off).
4. Press and release RESET (listen for click; Reset button will
latch, and on some devices, a green light will turn on). The
power supply cord is ready for operation.
NOTES:
The Reset button must be pushed in for proper operation.
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
Do not use the power supply cord as an off/on switch.
A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
Prepare Air Conditioner for Installation
Prepare unit for installation
1. Remove two front attachment screws.Separate the outer case
from the front with a putty knife at the catch points designated by the
arrows.
2. Remove the two screws on top of the outer case.
3. Using the basepan handle, slowly and evenly pull chassis out from
outer case.
5