Cembre SD-15P-ECO Manual De Uso Y Mantenimiento página 13

9. REPLACING THE SPINDLE
For augers having a Ø 16 mm shank, the "MND1" spindle must be interchanged with the stand-
ard "MND" spindle.
Replace the spindle as follows:
9.1) Removing the "MND" spindle
– Remove the detachable guard PRM-UN and the auger (see § 4.1.1).
– Turn the fi xed guard (23) and remove from the spindle, exposing the spindle shaft (15).
– By means of the 4 mm allen key supplied with the machine, remove grubscrew (18).
– Remove circlip (16) and locating pin (17).
– Slide the spindle from the shaft (13).
9.2) Fitting the "MND1" spindle
– Slide the "MND 1" spindle onto the shaft (15). Ensure that the spindle guide (19) is correclty po-
sitioned.
– Align the hole on the shaft (13) with the corresponding holes on the spindle (20).
– Insert the locating pin (17) and fi t the circlip (16).
– Fit and tighten the grubscrew (18).
– Fit the fi xed guard (23).
– Insert and secure the auger (Ø 16 mm shank); (see § 9.3).
– Fit the detachable guard PRM-UN (see § 4.1.2).
9.3) Fitting and removing the auger on the "MND1" spindle
– Turn the emergency lever (12), align the two
grooves on the auger with the red reference line
on the end of the spindle and fully insert the auger.
– Release the emergency lever (12).
To remove the auger, turn the emergency lever
(12) extract the auger from the spindle.
10. RETURN TO CEMBRE FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem and
give you the necessary instructions on how to dispatch the tool to our nearest service Centre;
if possible, attach a copy of the Test Certifi cate supplied by CEMBRE together with the tool or
fi ll in and attach the form available in the "ASSISTANCE" section of the CEMBRE website.
13
(See Fig. 1 and 2)
Grooves on the
auger
Red reference line
on the spindle
ENGLISH