General Troubleshooting - Ampro TECSHOW STRATUS 1000 Manual De Usuario

7. GENERAL TROUBLESHOOTING

Symptom
No output or short output
No output or spitting fluid
Fuse keeps blowing
Product does not power up
Product stops pumping/ Loud
noise
If you still experience problems after trying the
solutions presented here, contact AMPRO Technical
Support.
P. 10
Tecshow Stratus 1000 |
English version
Possible Cause
Line blockage or air in fluid line
Incorrect fluid
Incorrect fluid
Blocked pipes
Failing part
Excessive load on the circuit
Short circuit along the power lines
No energy on power outlet
Loose or damaged power cord
Blown fuse
Internal problem
Low/NO Fluid
Design and product specifications are subject to
change without prior notice.
Possible Action
Make sure there is fluid in the tank
Turn fog machine 45° to flatten out
the bubble and allow the fog fluid
to flow properly
Turn off the product for 5 seconds,
and then turn it back on. Repeat
as necessary.
Note: After more than 10 at-
tempts, contact Customer Service.
Clean thoroughly with AMPRO
FCQ. For full instructions, see
Fogger Maintenance. Refill with
AMPRO water-based fog fluid.
Clean thoroughly with AMPRO
FCQ. For full instructions, see
Fogger Maintenance. Refill with
AMRPO water-based fog fluid.
Contact Customer Service
Contact Customer Service
Make sure that the total load does
not exceed 80% of the breaker or
fuse nominal current
Check the power lines and power
cords
Check power outlet
Change to another outlet
Check the power cord
Replace blown fuse with a good
one of the same type and rating
Send product for repair
Refill product with fluid