Fuse Replacement - Ampro TECSHOW STRATUS 1000 Manual De Usuario

4. SETUP
AC Power
To determine the product's power requirements
(circuit breaker, power outlet, and wiring), use the
current value listed on the label affixed to the prod-
uct's back panel, or refer to the product's specifi-
cations chart. The listed current rating indicates
the product's average current draw under normal
conditions.
• Always connect the product to a protected
circuit (circuit breaker or fuse). Make sure the
product has an appropriate electrical ground to
avoid the risk of electrocution or fire.
• To eliminate unnecessary wear and improve its
lifespan, during periods of non-use completely
disconnect the product from power via breaker
or by unplugging it.
Never connect the product to a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or
dimmer channel serves only as a 0 to 100% switch.

Fuse Replacement

1. Disconnect the product from power.
2. Twist the fuse holder cap counterclockwise to
loosen the fuse holder and pull straight out.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and rating.
5. Screw the fuse holder cap back in place and
reconnect power.
• Disconnect the product from power before re-
placing the fuse.
• Always replace a blown fuse with another of the
same type and rating.
Mounting
Before mounting the product, read and follow the
safety recommendations indicated in the Safety
Notes.
P. 6
Tecshow Stratus 1000 | English version
Orientation
This product may not be tilted. This product should
only be mounted/used on a level surface.
Rigging
• Before deciding on a location, always make
sure there is easy access to the product for
maintenance and fluid replenishment.
• Make sure that the structure or surface onto
which you are mounting the product can sup-
port the product's weight (see the Technical
Specifications).
• When mounting the product overhead, always
use a safety cable. Mount the product securely
to a rigging point, such as an elevated platform
or a truss.
• When rigging the product onto a truss, you
should use a mounting clamp of appropriate
weight capacity. The bracket has 13-mm holes,
which are appropriate for this purpose.
• The rubber feet also serve as floor supports
and allow for surface mounting. When mount-
ing the product on the floor, make sure that the
product and cables are away from people and
vehicles.
Mounting Diagram
Safety
Cable
Bracket Adjustment Knob
Mounting
Clamp
Mounting
Bracket
Nozzle