Weidmuller THM MultiMark Plus Manual Del Usuario página 58

Fault Correction
7 Fault Correction
7.1 Error Display
The appearance of an error will be shown on the display:
Figure 19 Error display
The error treatment is pending on the error type → „7.2 Error Messages and Fault Correction" on page 58.
The display offers the following possibilities to continue after an error occurred:
Symbol Function
Repeat
The print job will be continued after clearing the error cause.
Cancel
The print job will be cancelled.
Feed
The paper feed will be synchronized. Following Repeat the print job can be continued.
Ignore
The error message will be ignored. The print job will be continued possibly with limit-
ed performance.
Save log
The error does not allow print operation.
For detailed analysis several system files can be saved on an external memory.
Table 5 Button in the error display
7.2 Error Messages and Fault Correction
Error message Cause
Barcode error Invalid barcode content, e.g. alphanu-
meric characters in a numerical barcode
Barcode too big The barcode is too big for the allocated
area of the label
Buffer overflow The input buffer memory is full and the
computer is still transmitting data.
Cutter blocked Cutter cannot return into its home posi-
tion and stays in an undefined position
No cutter function
Cutter jammed The cutter is unable to cut the labels but
is able to return into its home position
58
Remedy
Correct the barcode content.
Reduce the size of the barcode or move
it.
Use data transmission via protocol (pref-
erably RTS/CTS).
Switch off the printer. Remove material.
Switch on the printer. Restart print job.
Change material
Switch the printer off and then on.
If error recurs call service.
Press Cancel
Change material.
2599440000/00/04.2019