Metabo WPB 36-18 LTX BL 110 IK Manual Original página 17

household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs to
your Metabo dealer!
Do not throw battery packs into water.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/96/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
15. Technical Data
Explanatory notes on the specifications on page 2.
Subject to change in accordance with technical
progress.
U = Voltage of battery pack
D =max. diameter of accessory
max
t = max. permitted thickness of the clamping
max,1
shank on accessory when using two-hole
nut (10)
t = cup wheel: max. permitted thickness of
max,3
accessory
M = Spindle thread
l = Length of the sanding spindle
n = No-load speed (maximum speed)
P = Rated input power
1
P = Power output
2
m = Weight (with smallest battery pack)
Measured values determined in conformity with EN
60745.
direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (surface
h, SG
grinding)
a = Vibration emission value (disc
h, DS
sanding)
K = Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L = Sound-pressure level
pa
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed 80
dB(A).
Wear ear protectors!
ENGLISH en
17