Publicidad
Idiomas disponibles
Idiomas disponibles
STOPPING
To stop the machine, press the OFF "O" switch.
When not using the machine, turn it o and disconnect the plug from the socket.
Motor protection (where tted)
The machine can be equipped with a motor trip switch designed to prevent electrical failures. Should the switch operate during
use, just press the reset button followed by the start-up button in order to restart the machine.
MACHINE SERVICE TYPE
Use the machine only in the manner prescribed. The aim is to avoid excessive overheating and engine damage.
S6 40% / 2000W = the engine can be operated on a cycle basis of 10 minutes, to the power of 2000W for a period equivalent to
40% (4 minutes) the duration of the cycle followed by a period of functioning to a empty (without cutting ) for a period
equivalent to 60% (6 minutes) of the remaining duration of the cycle.
WARNINGS AND ADVICE
!!WARNING! Before conducting checks and adjustments, turn the switch to the OFF "O" and unplug the machine from the
electric power supply.
After having read the previous chapters carefully, apply these tips scrupulously to obtain maximum performance from your
machine. Proceed calmly. You will only be able to make full use of the machine's potential after gaining su cient experience.
Acquaint yourself with all controls. Run tests without work pieces.
OPERATOR
The normal operator position is in front of the machine, with both hands pushing the piece towards the blade while exerting
slight pressure on the surface. During the nal stage, the operator uses the piece pusher with one hand only ( g. L).
Warning! Keep your hands and face far from the blade and cutting area. Serious injury hazard!
WORK PIECE
The shape, size and weight of the piece to be cut must be compatible with the machine.
Mark the cutting line on the piece with a ruler. Position it on the machine surface (pos.17), taking care not to touch the blade, and
rest it sideways against the piece guide (pos.19) that you previously adjusted. The wider side of the piece must rest on the
surface; do not cut pieces with the wider side upright.
Warning! For your safety, it is important that the machine is secured to the bench or stand.
Pieces of de ned dimensions can be assembled on this machine. To support long pieces a pedestal must be used to be arranged
behind and/or alongside the machine, which prevents the 2 pieces from tipping over, causing danger for the operator.
Align the line traced previously with the theoretical surface the piece shall create with its straight motion through the blade.
!!WARNING! For your safety, it is important that the piece is correctly locked. Do not cut circular sections, old or fragile wood,
irregular wood, cracked wood, wood with nails or screws, branches or trunks. Always carefully inspect the piece.
!!WARNING! Always remember that a kickback causes the rejection of the piece, which is ejected towards the operator.
TOOL
Make sure the blade is integral, without cracks or deformations before use. Periodically check blade sharpness.
When necessary, replace it following the instructions in the next chapters.
Warning! Blade e ciency and perfect integrity provide better results and minimize accident risks.
CHIP AND DUST VACUUM
The machine can be equipped with a manifold for the suction of sawdust. Please remember that the part of material removed
while cutting will also be thrown around the machine and on the piece.
Connect the manifold to a wood sawdust suction system, using a plastic exible tube (both not supplied with the machine); your
dealer can suggest the most suitable choice.
Warning! Do not start the machine if the vacuum tube is not installed. Do not insert your ngers or tools in the manifold in
the attempt to remove material. Serious injury hazard!
12
www.ELITETOOLS.co
Keep Working
Publicidad
