Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONS, CUTTING AND MOVEMENTS
The blade is xed to the machine, while the piece moves manually in a straight and parallel line in relation to the blade. The
motor provides power to rotate the tool, using a set of gears.
Observe the following warnings that apply to all types of cuts:
- Make sure that levers and screws are tightened to rmly secure mobile parts
- Keep the work piece rmly
- The piece must rest against the surface and the piece guide
- Do not cut several pieces simultaneously
- Keep a safety distance from the cutting area
- Gradually and cautiously near the piece to the blade
- Cut in a single stroke
- Do not force the piece against the blade so as not to strain the blade and the engine
- Excessive strains cause the blade and/or piece to suddenly break
- Do not strain the blade laterally
- The idle blade should not touch the piece
- Do not start the machine if the blade is in contact with the piece
- Do not start the machine if the higher guard is not covering the blade
- Do not start the machine if the removable guard is not positioned over the blade underneath the work surface
- To clean the cutting area, use a brush with a long handle
CUTTING ALONG THE AXIS OF THE PIECE
Initial position:
- Piece guide installed on the work surface
- If the function for blade height adjustment is tted, use the handwheel to ensure that the blade sticks out a couple of
millimeters beyond the thickness of the piece to be cut
- If the function for tilted cuts is tted, adjust the blade inclination using the handwheel and then lock it in this position with the
lever/handwheel
Cutting:
- Press the switch to start the machine
- Using both hands, push the piece against the blade (enclosed in the guard) at a uniform speed and, at the same time, press the
piece onto the work surface and on the piece guide. The part will cause the guard to lift and to rest onto the piece keeping the
blade protected
WARNING! Keep hands away from the cutting area.
- When your hands get closer to the blade, use the piece pusher to complete the cut
- Turn o the machine.
SLANTED CUT
WARNING! Carrying out this cut means that the hands are located in the area adjacent to the cut and the danger of serious injury
is therefore greater: take care of your hands and keep a safe distance.
WARNING! It is forbidden to carry out this type of cut on long pieces, such as planks, beams, etc. Only use pieces of a limited length.
Initial position:
- Piece guide with goniometer installed on the work surface
- If the function for blade height adjustment is tted, use the handwheel to ensure that the blade sticks out a couple of
millimeters beyond the thickness of the piece to be cut
- If the function for tilted cuts is tted, adjust the blade inclination using the handwheel and then lock it in this position with the
lever/handwheel
Cutting:
- Press the switch to start the machine
- Using both hands, push the piece against the blade (enclosed in the guard) at a uniform speed and, at the same time, press the
www.ELITETOOLS.co
Keep Working
13
Publicidad
