Operating Instructions
Placement
Set up your NANOreel near the pipe en-
trance so you can manipulate the push
cable while viewing the display. Use the
kickstand to position the NANOreel so that it
does not tip during use.
Opening the NANOreel Case
WARNING
Make sure the camera is completely in-
side the drum before unlatching and
opening the NANOreel case. Do not open
the NANOreel case while the camera is
stored in the camera clip. If the camera
is not in the drum, the push cable can
unwind and cause damage or serious in-
jury.
Open the NANOreel case to route the cam-
era, replace the drum, rewind the push
cable, and to maintain and clean the system.
1. Set the unit on a level surface and lay
it on its back.
2. Unfasten the case latches on either
side of the NANOreel.
Verrou du boîtier
3.
Carefully open the front case and lo-
cate the camera head in the push
cable drum.
4. Route the camera head out through
the push cable guide in the front of the
case.
5. Secure the camera head in the clip.
6. Close and relatch the case.
NANOreel – English – 11
Case Latch