Publicidad
Idiomas disponibles
Idiomas disponibles
3.4 - OTHER FUNCTIONS
3.4.a - LED light
Press the key (A7) for a few seconds to activate/deactivate the LED light (8).
When the function is active, the light varies between 7 shades of colour.
3.4.b - WIFI function
When switched on, the appliance enters the device search mode and the LED (L9) flashes.
In case it is desired to activate the function in a second step, keep the key (A1) pressed for a few seconds until
the LED (L9) starts to flash.
When the appliance connects with the smartphone, the LED (L9) stops flashing and
remains steady on on the display.
Frame the QR code to download the instructions for connection to the WiFi network and
for use of the App.
If the appliance does not connect within 2 minutes, the LED (L9) stops flashing.
3.4.c - Absence of water
The appliance stops working without water inside the tank, the LED (L2) lights up red and switches off automatically
after 10 seconds; the appliance enters stand-by mode.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning inter-
vention, always make sure you disconnected the power plug
from the power socket.
•
Use a dry cloth to clean the appliance.
•
If the appliance is very dirty, it is possible to use a cloth dampened with warm water
(max 50°C) and a mild detergent to clean its external parts. Dry with a dry cloth.
•
Remove the tank and empty all water from unit bowl and tank (Fig.6).
Locate the ultrasonic disk on the inside centre of the base unit; ONLY use a soft paintbrush to delicately clean
•
the disk and remove accumulations and deposits.
Do not scrub or scrape the ultrasonic disk.
• Make sure the appliance is completely dry before reconnecting the plug to the power socket.
• Do not use a chemically treated or antistatic cloth to clean the appliance.
• Do not use petrol, solvents, polishing pastes or similar. These products could break or deform
the plastic surface.
• Do not use oils, chemical substances or abrasive products to clean the appliance.
• Neither wash nor immerse the appliance with/in water.
•
Remove the thermal protection (11) and clean the inside of the appliance body (5); when the inside of the appliance
has been cleaned, make sure to correctly reposition the protection and check that no water residues remained in the
various components (Fig.7).
•
Remove the filter (4) and rinse it under running water. Make sure the filter (4) is completely dry and reposition it inside
the appliance (Fig.8).
In case of an appliance malfunction, do not try to disassemble it but instead refer to the retailer or
to the technical assistance service.
EN - 7
LIMPIA HERO
Publicidad
