Main Menu - Televes Avant3 Manual De Instrucciones

Main menu

From this time, press shortly the
the main menu in the following sequence: Inputs,
Filter 1, ..., Filter 5, and Filter VHF. , , ,
Remark:
To change the interface language before
starting the confi guration of the device, you
must access the language menu. To do so,
press the key (long press) from the Input
menu to access the Extended menu, and then,
using the keys or
Finally, press the key (long press) to save the
changes.
For more information, see section Extended
Menu => Language selection.
Confi guration of inputs
The fi rst menu displayed is the "Inputs menu. "
The mapping of the keys in this menu is:
& Scroll through the menu options: 5-0,
2-3.
(Short press) - Positions the cursor over
each modifi able parameter.
(Long press) - Calls the extended menu
(language).
(Short press) - Shifts to the next main
menu.
(Long press) - Recording of parameters.
To change the value selected with the cursor, you
must press the key
fl ashing. Next, change its value directly by
keys.
key to scroll
, select the language.
then that value will start
or
Programming of fi lters
Pressing the key, you access the second menu,
Programming Filters. The mapping of the keys in
this menu is:
Selection of upper and lower channel fi lter.
(Short press) - Positioning of the cursor.
(Long press) - Not applicable
(Short press) - Moves to the next menu.
(Long press) - Recording of parameters.
FILTER 1
__
Press the key (short press) to activate the fi rst
channel of Filter 1. Use the keys
select the lower channel of the fi lter. Press the
key (short press) to activate the upper channel of
the fi lter. Use the or
channel of the fi lter.
FILTER 1
_ _
25 __
Above the channel value it can be seen a graphic
representation of the fi lter, which becomes wider
as we increase the width of the fi lter.
Filters can be stretched up to 7 channels bandwidth,
from channel 30 onwards. If the lower end of
the fi lter is below the channel 31, the maximum
channel bandwidth is limited to 5 channels.
Modifying the lower end of the fi lter, automatically
deletes its upper end.
The range of channels that can be entered is the
following:
UHF: --, 21, ..., 69
If there were overlapping of fi lters, the display
shows the fi lter which is in confl ict and then the
unit is not able to record data.
and , to
keys to select the upper
FILTER 1
_ _
25 28
23
EN