Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-WP-A-ACWP Series
MOUNTING USING CONDUIT
1.
Remove lens assembly by loosening screws on side of frame.
Swing lens assembly open and slide lens assembly on hinges to
remove from mounting box. See Figure 1.
2.
Remove appropriate conduit plug from back wall or side of
mounting box.
3.
Drill holes at (3) knockout locations around the perimeter of the
mounting box for attachment of fixture to mounting surface. See
Figure 4.
4.
Attach conduit to mounting box at chosen threaded opening.
NOTE: To ensure a watertight seal, teflon tape should be used on
conduit threads.
5.
Attach the mounting box to the mounting surface using customer
supplied fasteners appropriate for the mounting surface. Fasteners
should be passed through the knockout holes removed in Step 3
and threaded into mounting surface.
NOTE: A high grade caulking material, such as silicone rubber,
should be used between the three gaskets at the fastener
locations and the mounting surface to prevent water entry into the
fixture.
NOTE: A bubble level is provided on mounting box to aid in
leveling box.
6.
Replace the lens assembly on hinges, but do not close.
7.
Use switch inside lens assembly to set desired color temperature.
See Figure 5.
NOTE: Power must always be OFF when adjusting color
temperature.
NOTE: Factory setting is 4K.
8.
Fixture is supplied with a photocell to switch the unit on at dusk
and off at dawn. If photocell control of fixture is not required,
disconnect photocell by unplugging connector from photocell. See
Figure 6.
9.
Rotate knob inside lens assembly to select desired wattage for
fixture. See Figure 7.
NOTE: Power must always be OFF when adjusting wattage.
NOTE: Factory setting is maximum wattage.
10. Make wiring connections per the Electrical Connections section.
11. Swing lens into closed position. Retighten screws that were
loosened in Step 1 above.
FIGURE 3
http://lighting.cree.com/warranty
Document:
LPN00875X0001A0_A
Created By:
TMT
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
|
866.924.3645
Date
01-11-2023
Photocell Connector
Publicidad
