Ryobi RY10521A Manual Del Operador página 13

FILLING THE FUEL TANK
See Figure 2.
 Clean the surface around the fuel cap to prevent
contamination.
 Loosen the fuel cap slowly, by turning counter-
clockwise.
 Carefully pour the fuel mixture into the tank.
Avoid spillage.
 Prior to replacing the fuel cap, clean and inspect the
o-ring.
 Immediately replace the fuel cap and hand
tighten, by turning clockwise. Wipe up any fuel
spillage.
 Move at least 30 ft. away from refueling area
before starting the product.
NOTE: It is normal for the engine to emit smoke
during and after the first use.
OPERATION
ADDING BAR AND CHAIN LUBRICANT
See Figure 3.
Use RYOBI Bar and Chain Lubricant. It is designed
for chains and chain oilers, and is formulated to
perform over a wide temperature range with no dilu-
tion required. Chain saw should use approximately
one tank of lubricant per tank of fuel.
NOTE: Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
 Carefully pour the bar and chain lubricant into
the oil tank.
 Fill the oil tank every time you fuel the engine.
Fig. 2
Page 13 — English
Fig. 3