Publicidad
Idiomas disponibles
Idiomas disponibles
6. Installation
Install the mixer horizontally. The maximum
permissible inclination angle is plus-minus 40 °.
Only lift the mixer in the suspension point.
Lifting equipment and a chain or wire designed for
lifting and lowering the mixer into the pit or tank are
available as accessories. Do not use the equipment
as universal lifting equipment.
Never hang the mixer by the power supply
Caution
cable.
Always have at least 3 m free cable above
the liquid level. This limits installation
Caution
depth to 7 m for mixers with 10 m cable.
6.1 Positioning
Correct positioning of the mixer is essential to
ensure trouble-free operation and long life.
Observe the following guidelines:
•
The mixer must always be completely
submerged.
•
The mixer must be placed in such a way that a
good mixing of the liquid in the entire pit or tank is
obtained. If more mixers are installed in the same
pit or tank, the mixers must not generate opposite
flows.
•
The distance between the propeller tip and the pit
or tank bottom and walls must be at least 10-20
cm.
•
The distance between the propeller tip and the
surface of the liquid must be at least 10 cm.
6.2 Installation instructions
You can mount the mixer in different ways,
depending on the accessories:
•
mounting bracket and tube for suspended
mounting, fig.
3
•
mounting bracket for wall mounting, fig.
•
fixation base for bottom mounting, fig.
•
motor bracket for mounting on column profile, fig.
4.
Fig. 3
3
3
Fig. 4
Suspended mounting, wall mounting
and bottom mounting
175
Mounting on column profile
7
Publicidad
