SCANCOOL GBC05X Manual De Usuario página 23

EN
Electrical connection
Electrical connection must be carried out by an AUTHORISED TECHNICIAN
The legal standards in force in each country regarding connection to the mains should be taken into
account.
The manufacturer will not be held liable for any personal or material damage to the
machine resulting from incorrect installation or failure to comply with the manufacturer's
specifications.
The electric specifications of the machine are shown in the specification plate. Section 3.
Drainage connection
If you want to place the drain in a fixed and definitive location, it must be connected to a general
drain, creating a siphon with said drain to avoid cold losses. This operation must be carried out by
qualified personnel. See Figures 1 - 4 for the location of the drain.
Recycling
The product packaging consists of:
•
A wooden pallet.
•
Cardboard.
•
A polypropylene band.
•
Expanded polystyrene.
All the packaging used around the machine can be recycled; The correct disposal of these products
will help to protect the environment. For further information regarding the recycling of these products,
please refer to the relevant office of the local body. Dispose of these materials in accordance with
current legislation.
•
Check that the mains voltage corresponds to that indicated on the nameplate.
•
It is essential that the electrical installation where the cabinet is going to be
connected has an GROUNDING SOCKET, in addition to the appropriate
magneto-thermal switch and differential protection (we recommend 30 mA)
•
The appliance must be grounded using a differential protector. The
manufacturer will not be held liable for damage originated by failure to observe
this requirement.
•
The cross-section of the power cable must be suitable for the rated current of
the machine.
•
The plug should be Schuko type with grounding and terminals of 4.8mm
(F type). It is forbidden to enlarge the plug for your safety. As optional, the
equipment can be supplied with British type plugs (H type) or American type
plugs (B type).
•
If any faults are observed during the installation, the supplier should be notified
immediately.
•
Do not install the Blast Chiller outdoors.
•
In case of fire do not use water. Use CO2 (carbon dioxide) extinguishers and
cool the engine area as fast as possible.
21