Battery Maintenance; Storage And Transport - SDMO RL6-1b Manual De Uso Y Mantenimiento

9.4. Battery maintenance

Fit the battery so that it is properly ventilated.
Maintenance should only be carried out by a qualified person.
If replacing batteries, only use the same type as those to be replaced. Do not throw the old battery in the fire.
Only use insulated tools (the operator should not be wearing a watch, bracelet or any metal object)
Never use sulphuric acid or acid water to top up the electrolyte level.
Batteries release oxygen and hydrogen gas, which are flammable
Never use flames or generate sparks near the battery since this might cause an explosion.
Discharge any static electricity on your body before handling the batteries by first touching an earthed metal surface.
Do not use the battery when the fluid is below the minimum required level. Using a battery with a low electrolyte level
could result in an explosion.
Do not short circuit the battery terminals with a tool or other metal object.
When disconnecting battery cables, remove the cable from the negative (-) terminal first. When reconnecting the
battery, connect the positive cable (+) first.
Charge the battery in a well-ventilated area, with all filler hole plugs removed.
Make sure that the cable clamps are correctly secured to the battery terminals. A loose cable clamp can cause
sparks that could result in an explosion.
Before servicing electrical components or performing electric welding, set the battery switch to [OFF] or disconnect
the battery negative cable (-) to cut off the electrical current.
Electrolyte contains dilute sulphuric acid. Incorrect handling of the battery could lead to a loss of sight and burns.
Wear safety goggles and rubber gloves when working on the battery stopping-up the electrolyte, recharging the
battery, etc.)
If electrolyte comes into contact with your skin or clothes, wash it off immediately with plenty of water. Then wash
thoroughly with soap.
If electrolyte comes into contact with your eyes, rinse immediately with plenty of water and see a doctor as soon as
possible.
Danger
Should you accidentally swallow electrolyte, gargle with plenty of water, then drink lots of water. Consult a doctor
immediately.
Electrolyte spillages should be rinsed using a neutralising agent. A common method is to use a solution of 500g of
bicarbonate of soda diluted in 4 litres of water. The bicarbonate of soda solution should be added until it is clear the
reaction has finished (foaming). The remaining liquid should be rinsed off with water and left to dry.

9.4.1 Storage and transport

Batteries ready for use must be stored in a cool and dry place (frost-free) protected from the sun (self-discharge).
Batteries must be transported and stored vertically (risk of acid spillage).
Leave the terminal cover on the positive terminal.
75/372