Yamaha ATS-1080 Manual De Instrucciones página 49

Information for qualified contractors or dealers
Mounting the unit on a wall
Mount the unit on a wall so that the touch panel faces forward.
Remote control Touch panel
sensor
CAUTION
▪ To prevent the unit from falling, attach it to a wall constructed of drywall
(plasterboard).
▪ Make sure you use screws (sold separately) that can support the weight of the
installation. Using clamps other than specified screws, such as short screws,
nails, and two-sided tape, may cause the unit to fall.
▪ Fix the cables in place where they will not become loose. If your foot or hand
accidentally gets caught on a loose cable, the unit may fall.
▪ Do not lean on the unit or apply excessive force to the top of the unit. Doing so
may cause the unit to fall.
▪ Check that the unit is fixed securely after the installation. Yamaha will bear no
responsibility for any accidents caused by improper installations.
1
Attach the mounting template (supplied) on a wall
and mark for the screw holes.
Tapes or thumbtacks
49
En
Mounting template (supplied)
Screw holes