Bosch MRF23EVS Instrucciones De Funcionamiento Y Seguridad página 22

BM 2610033452 02-14_MR23EVS 3/3/14 9:50 AM Page 22
MAXIMUM BIT/CUTTER SIZE FOR
TEMPLET GUIDES
When using a templet guide, use only router
bit with cutters that are 1/16" less than the
internal diameter of the templet guide, such as
in the table below.
Bosch
Templet
Guide
RA1101
RA1103
RA1105
RA1107
RA1109
RA1111
RA1113
RA1115
RA1117
RA1119
RA1121
Your router can also be used in a router table.
The MR001 fixed base is designed to allow
easy depth adjustment in a table.
The MRP01 Plunge Base is
C UTION
not recommended for use in
a router table. Damage to plunge router base
may occur.
To eliminate the hassle of installing your
router's own base on the router table and later
having to convert it back for non-table use,
Bosch offers additional MRF01 Fixed Bases
separately so that one base can be
permanently attached to your router table,
leaving your other fixed base available for non-
table use.
Bushing External
Depth Diameter
A
3/16"
9/64"
9/64"
5/16"
7/16"
3/16"
1/2"
3/16"
31/64"
31/64"
7/16"
Use in Router Table
USE WITH THREADED
TEMPLET GUIDES
Also available as an optional accessory is an
additional adapter, the RA1100, that allows
use of conventional threaded templet guides
with the Bosch quick-release system.
Internal
Diameter
B B
5/16" 1/4"
5/16" 17/64"
7/16" 3/8"
7/16" 3/8"
1/2" 13/32"
5/8" 17/32"
5/8" 17/32"
3/4" 21/32"
13/16" 5/8"
1" 25/32"
1-3/8" 1-19/64"
ATTACHING BASE TO
MOUNTING PLATE
Attach the MRF01 to the router table's
mounting plate using the three M4 holes
screws provided. The 3-hole pattern on the
bottom of the base follows the industry-
standard three-hole pattern for professional
routers. Depending on the thickness of your
router table or router table mounting plate, you
may need to purchase longer M4 screws with
tapered heads (Fig. 21).
If your router table mounting plate does not
have countersunk holes in either of those
patterns, you will need to determine the hole
locations, drill and countersink them, also
locate and drill a hole for the over-table
adjustment wrench.
-22-
Max
Bit/Cutter
Diameter
3/16"
13/64"
5/16"
5/16"
11/32"
15/32"
15/32"
19/32"
9/16"
21/32"
1-15/64"