Publicidad
Idiomas disponibles
Idiomas disponibles
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to
the ON position. Test light and dimmer function and then
test fan speeds. Next, locate handheld remote control. Test
fan speeds with the different fan speed buttons (I - VI) on
handheld remote control. Test the light ON/OFF function
by pressing the
button; test the dimmer function by
pressing the
button and holding it down for up to
5 seconds. If the wall and/or remote control operates all of
the functions of the fan, battery/batteries has/have been
installed correctly. If the wall and/or remote controls do
(does) not operate all of the fan functions, refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Fan must be on LOW before setting the fan in reverse.
Use
button to recirculate air depending on the
season. A ceiling fan will allow you to raise your
thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
NOTE: If the wall control/handheld remote control
interferes with other appliances, activate a new code on
the wall control/ handheld remote control by turning the
power off first. Go back to the instructions for the SET
button in Section 11 (page 11).
IMPORTANT: Handheld remote control and wall control
must be synchronized with fan in order to properly
function.
page 12
III IV
II
V
I
VI
OFF
ON
III
IV
II
V
VI
I
Publicidad
