Craftmade KNE48 Guia De Instalacion página 12

13. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF
slider switch on wall control, then set to the ON
position. Test light and then test fan speeds. Next,
locate handheld remote control. Test the light
ON/OFF function by pressing the L button; Test
fan speeds with the different fan speed buttons. If
the wall and/or handheld remote control operates
all of the functions of the fan, battery (batteries)
has (have) been installed correctly. If the wall
and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch (located on top of motor housing).
Set reverse switch to recirculate air depending on
the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 3), fan will not operate.
NOTE: If the wall control/handheld remote
control interferes with other appliances, turn
power off first and then go back to the
instructions in Section 11.
reverse
switch
diagram 1
page 12
motor
housing
diagram 3
diagram 2