Probuilder 43609 Manual De Instrucciones página 34

• Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
• Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may aff ect the power
tool's operation. If damaged, have
the power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
• Use the power tool, accessories, and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations diff erent from those intended
could result in a hazardous situation.
Service
• Have your power tool serviced by a
quali� ed repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
34
Special safety instructions
Always unplug the jig saw before changing
the blades or making any other adjustments!
Do not use for cutting pipes or cables.
Do not use cracked, blunt or damaged
blades.
Do not start the saw if no blade is � tted.
Check there are no obstructions in the
surface under the item to be cut.
Do not attempt to cut items thicker than
the maximum cutting depth of the blade, or
where there is insuffi cient clearance for the
blade under the item.
The saw's metal parts may become
conductive if the saw comes into contact
with a live wire. You should therefore only
hold the jig saw by its insulated handle.
Check that the motor's vent holes are not
blocked.
Always wear a face mask if excessive
amounts of dust are generated or if sawing
hazardous materials.
Never remove dust, obstructions or the
like from the work area while the blade is
operating.
Never stop the saw blade by pressing against
the saw, or by applying pressure to the side
of the saw blade.
Do not lift the saw from the item being cut if
the blade is still running.
Never place the jig saw on a table or
workbench if it has not stopped completely.
The saw blade will continue to run a short
time after the machine has been switched
off .
Do not touch the blade or metal � lings until
they have cooled.