Klauke MAP 1 Manual De Instrucciones página 29

Instruction Manual MAP 1
_______________________________________________________________________________________________________________________
The crimping cycle is terminated when the dies are completely closed and the max. crimping
force is reached which is indicated by the auto retraction of the piston.
Attention
After having terminated the pressing process and prior to changing the dies
remove battery (Pos.-No. 5) to avoid unintended starts.
5.2. Explanation of the application range
The MAP 1 is a hand guided pressing tool to mount fittings on multi Layer, copper and
stainless steel type plumbing tubes with ∅ 12 to 32 mm. The unit is not supposed to be
restrained in a vise. It is not allowed to use the tool in a stationary application.
The tool is not designed for continued crimping operations. After a sequence of approximately
50 completed crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly
inflammable or explosive liquids and materials
Attention
Electric tools should not be operated in pouring rain or under water.
page 29