Publicidad
Idiomas disponibles
Idiomas disponibles
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Press the lamp switch to light up the lamp. Press the
lamp switch again to turn off the lamp. When the tool is
left without any operation for about 60 seconds with the
motor stopped, the lamp goes out.
► Fig.5: 1. Lamp 2. Lamp switch
NOTICE:
Use a dry cloth to wipe the dirt off the lens
of the lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Selecting the speed mode
NOTICE:
Change the speed mode only after the
tool comes to a complete stop.
The tool employs the speed mode changing knob. Turn
the knob so that the arrow on the knob points toward
one of the two modes below;
1
Slow speed mode: Dispense grease at constant slow
speed.
2
Auto speed mode: Apply grease while varying the
flow rate automatically according to pressure of supply
destination.
► Fig.6: 1. Speed mode changing knob
Pressure relief valve
When the internal pressure in the tool exceeds a certain
level, grease comes out from the pressure relief valve to
lower the internal pressure.
► Fig.7: 1. Pressure relief valve
CAUTION:
When grease comes out from the
pressure relief valve, wipe off the grease with a
dry cloth or the like. Otherwise it may cause slipping
and result in an injury.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing or installing barrel
To remove the barrel, screw it as illustrated.
► Fig.8: 1. Barrel
To install the barrel, insert it into the tool then screw in
reverse.
► Fig.9: 1. Barrel
Rod handle
Pull the rod handle when installing grease in the barrel.
► Fig.10: 1. Rod handle 2. Rod
To lock the rod handle fully pulled, pull the rod handle
until the groove on the rod can be seen, and then hook
the groove onto the slot. To unlock the rod handle,
unhook the groove so the rod moves forward.
► Fig.11: 1. Groove 2. Slot
CAUTION:
Make sure the rod handle is locked
firmly. Otherwise it may be unlocked accidentally and
cause a pinching.
NOTE: To pull the rod handle while the barrel
installed in the tool, loosen the valve of the air drain to
let air comes into the barrel.
Hose holder
The hose holder can be attached to either side of the
tool with the screw.
► Fig.12: 1. Hose holder 2. Screw
Shoulder strap
WARNING:
yard (tether strap). Doing so may result in serious
injury because the strap hole is not intended for a
safety device for fall prevention.
WARNING:
holding the tool even if when using the shoulder
strap. Carrying the tool using only the shoulder strap
makes it unstable. The shoulder strap may come off
or the tool hit other objects and cause injury.
Attach the hooks of the shoulder strap onto the mounts
of the strap holes as shown in the figure.
► Fig.13: 1. Shoulder strap 2. Hook 3. Mount
OPERATION
Grease supply
WARNING:
manuals of the grease and/or other instruments
and replace the following contents as necessary.
Misuse or failure to follow the instructions may dam-
age the tool or cause an injury.
NOTICE:
When using the barrel with the old
grease remains, remove the barrel and purge the
old grease according to the section for purge of
grease.
11 ENGLISH
Never use the strap hole for lan-
When carrying the tool, keep
Make sure to read the instruction
Publicidad
