SCHOLTES TIC 740 DD L IT Manual De Instrucciones página 23

Installation
Before operating your new appliance please read this
!
instruction booklet carefully. It contains important information
concerning the safe operation, installation and maintenance of
the appliance.
! Please keep these operating instructions for future reference.
Pass them on to any new owners of the appliance.
Positioning
! Keep all packaging material out of the reach of children. It may
present a choking or suffocation hazard ( see Precautions and
tips ).
The appliance must be installed by a qualified professional in
!
accordance with the instructions provided. Incorrect installation
may cause harm to people and animals or may damage property.
Built-in appliance
Use a suitable cabinet to ensure that the appliance functions
properly.
• The supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
• If the appliance is to be installed above an oven, the oven
must be equipped with a forced ventilation cooling system.
• Avoid installing the hob above a dishwasher: if this cannot be
avoided, place a waterproof separation device between the
two appliances.
• Depending on the hob you want to install, the cabinet must
have the following dimensions ( see figure ):
V e n t i l a t i o n
To allow adequate ventilation and to avoid overheating of the surrounding
surfaces the hob should be positioned as follows:
• At a minimum distance of 40 mm from the back panel or any
other vertical surfaces.
• So that a minimum distance of 20 mm is maintained between
the installation cavity and the cabinet underneath.
• Kitchen cabinets adjacent to the appliance and taller than
the top of the hob must be at least 600 mm from the edge
of the hob.
F i x i n g
on a perfectly level supporting
The appliance must be installed
surface.
Any deformities caused by improper fixing could affect the
features and operation of the hob.
min. 20 mm
COMPARTMENT
min. 40 mm
min. 20 mm
FAN-ASSISTED
OVEN
min. 40 mm
FRONT SIDE
OF HOB
UNDERSIDE
OF HOB
GB
SUPPORTING
SURFACE
23