AMURA CASTOR 16A3D Manual De Instrucciones página 44

English
by default, to activate the clutch and that the engine
power is transmitted to the cutters, the clutch lever
must be pressed.
Attention !: The clutch lever has a safety lock to
prevent accidental clutch of the machine.
To act on the clutch, and for the machine to move
forward, first actuate the traction lever (1) and then
the clutch lever (2). Then release the pull lever (1) and
the machine will move forward.
Remember that
these levers will
change position
when you change
the direction of
the handlebar. The
position seen in
the drawing is with
the engine facing
the front of the
machine.
SHIFTING GEARS
This machine has three speeds in both directions.
These are shown as "I N II N III" If operating in one of
the directions you need to reverse gear, you can use
the machine direction change lever (5)
7.2. WORKING WITH THE MACHINE
Start the machine following the instructions in the
manual.
The moving wheels will pull the machine forward
maintaining the proper speed.
When working on slopes always stand a little higher
up the slope so that the machine is always below you.
7.2.1. SCORECARD
In the following drawing you can see the function of
the different levers of the machine.
44/144