Descargar Imprimir esta página

Klipsch KD-400 Manual Del Usuario página 17

Publicidad

Directive 2002/96/EC concerning waste of electrical and
electronic equipment (WEEE). This label indicates that this
product should not be disposed of with household waste.
It should be deposited at an appropriate facility to enable
recovery and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Approved under the verification provision of FCC Part 15 as
a Class B Digital Device.
Caution: Changes or modifications not expressly approved
by the manufacturer could void the user's authority to
operate this device.
Caution: To comply with the limits of the Class B digital
device, pursuant to Part 15 of the FCC Rules, this device
is to comply with Class B limits. All peripherals must be
shielded and grounded. Operation with non-certified pe-
ripherals or non-shielded cables my result in interference
to radio or reception.
This Class B digital apparatus complies with Canadian ICES-
003. CAN ICES-3 (B)/NMB-3(B) Cet appareil numérique de la
classe B est conforme à la norme NMB-003 du Canada.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
The term "IC:" before the radio certification number only
signifies that Industry Canada technical specifications
were met.
Le terme «IC:» avant le numéro de certification radio signi-
fie seulement que les spécifications techniques d'Industrie
Canada ont été respectées.
This device complies with part 15 of the FCC Rules and
the applicable Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference,
including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with FCC and IC radiation
exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance 20cm between the radiator and your
body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Cet appareil est conforme à FCC et IC l'exposition aux
rayonnements limites fixées pour un environnement non
contrôlé. Cet appareil doit être installé et utilisé avec
une distance minimale de 20 cm entre le radiateur et
votre corps. Cet transmetteur ne doit pas être co-situé
ou opérant en liaison avec toute autre antenne ou
transmetteur.

Publicidad

loading

Este manual también es adecuado para:

Kd-400pm