Bianchi E-ARCADEX Manual Del Usuario página 4

EN
DECLARATION OF CONFORMITY
The manufacturer F.I.V.E. Bianchi S.p.A., located at Via delle Battaglie, 5 - 24047 Treviglio (BG), Italy, hereby declares that its products conform with
standards 2006/42/CE, 2014/30/UE, 2011/65/EU, 2014/53/EU, UNI EN 15194:2018 and ISO4210. The products also conform with the provisions of Art.
50 of the Italian Highway Code (Italian Legislative Decree no. 285 of 30 April 1992, as amended, and as amended by Art. 24/1 of Law no. 14 of 3
February 2003), as defined by Art. 2, paragraph 1, letter n) of the Agreement.
The complete list of product codes and the relative compliance information can be consulted under the "Declaration of Conformity" link at
www.bianchi.com/manuals/.
GENERAL SAFETY WARNINGS
Please pay close attention to the following symbols.
DANGER!
indicates a potential danger which may cause serious injury or death if not avoided.
WARNING!
indicates practices and conduct to be adopted for safe product use.
INFORMATION!
Indicates additional information on how to use the product.
WARNING!
Please note that failure to comply with the warnings and provisions contained in this data sheet exempts the manufacturer of any liability.
INTENDED USE
ASTM CATEGORY 2 – Cyclocross, gravel, crossbike and trekking bikes, including the relative Pedelec e-Bike pedal-assist versions.
Designed for use on surfaces as per Category 1 (artificially paved surfaces such as asphalt roads and cycleways) as well as
unpaved roads with gravel, sand or similar surfaces (e.g., forestry roads, dirt roads, paved hiking trails with few tree roots). The
tyres remain in constant contact with the ground or only lose contact briefly due to uneven ground. Drops are limited to 15 cm
(6") or less.
FRAME AND FORK
Features: 100% carbon fibre frame and fork with tubing designed to add sportiness to the E-Arcadex.
Specifically designed to be compatible with the Bosch CX motor and integrated 500 Wh battery, mounted in a balanced position to optimise riding
agility.
Internal cable housing, casing and brake hoses.
The head tube is designed to house bearings from 1½".
The fork is tapered with a 28.6 mm diameter seat post.
The frame and fork are equipped with an M12 thru-axle to attach the wheels. Front 12 x 100, rear 12 x 142.
The frame is compatible with bottle cages mounted to the seat post and the down tube.
Compatibility: The frame is only compatible with electronic and mechanical wireless shifting systems.
The frame is not compatible with electronic cable shifting systems.
The maximum tyre width is 45 mm without mudguards, 40 mm with mudguards.
The frame conforms to standard EN15194.
The maximum load capacity of the bike, system weight*, is indicated on the EPAC label, located in the motor housing unit.
WARNING!
*
*System weight may vary depending on the set-up of each product. Please refer to the EPAC label on the product frame.
WARNING!
*
The measurement refers to the actual size and not to the image on the cover.
4