Bianchi E-ARCADEX Manual Del Usuario página 6

WARNING!
If the handlebar is damaged, stop using the bike immediately.
Do not use the bike until a specialist retailer has conducted a full inspection and, if necessary, the handlebar has been replaced.
THRU-AXLE
WARNING!
Use caution and observe the following
warnings. Failure to comply with the warnings
and provisions contained in this data sheet
exempts the manufacturer from any liability.
Unlike quick-release systems, the thru-axles
provided with this model are screwed directly
onto the frame and fork dropouts using an M12
screw. The length of the thru-axle is specific
to this model and must be observed in order
to be able to assemble the wheels safely.
(Images 1B and 1C)
DANGER!
The use of a thru-axle other than the one
provided may result in the incorrect assembly
of the wheel and may compromise the
integrity of the frame and fork.
WARNING!
Always use the thru-axles provided with the model.
DANGER!
Incorrectly mounted wheels may result in falls and serious accidents. If in doubt, contact your specialist retailer.
DANGER!
Never exceed the maximum torque value indicated on the axles. Incorrect tightening may damage the frame and fork.
SEAT POST CLAMP/EXPANDER
WARNING!
Use caution and observe the following warnings. Failure to comply with
the warnings and provisions contained in this data sheet exempts the
manufacturer from any liability.
The clamp/expander system provided is designed specifically for use
with the e-Arcadex frame (Image 1D)
Without this component, it is not possible to lock the seat post in the
desired position.
To set the saddle height, loosen the M5 screws on the seat post clamp.
The recommended torque for the clamp/expander is 6 Nm.
INFORMATION!
For optimum grip and to eliminate slippage between the seat post and
the frame, place a layer of gripper paste on the part of the expander
that is in contact with the seat post. (the gripper paste is included
with the product).
6
Image 1B
Image 1D
Image 1C