TensCare OVA Guia De Inicio Rapido página 8

Controls and Interface
Ova 3 comes with two stimulators both with separate LED
displays.
The LED displays are specific to the buttons on each
stimulator.
Note: When switching between modes to adjust
programme parameters the white LEDs will flash once.
Note: All LED'S on both stimulators will automatically
turn off after 10 seconds if no buttons are pressed. To
re-activate the LED's, press any button.
14
Completing a session
1) Turning Ova 3 on
To turn the unit on, press the Power button on the device for
approximately 1 second until the LED display shows. The unit
will start with the programme you used last.
Note: Ova 3 will automatically turn off if both strength
controls are set to zero for 1 minute.
2) Programme Selection
To select your desired programme, press the programme
button once to enter programme selection mode. (See
section 6 Pain Relief Programmes)
Once in programme selection mode, repeatedly press
the programme button to cycle between available
programmes.
This is indicated by a short beep as well as shown on the LED
display.
Note: When turning on Ova 3, the last programme and
timer settings will be set as default.
Note: If the programme button is pressed during a
session, the selected programme will change, and
intensity will be reset to 0.
15