Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS (CONTINUED)
Heater Locking Function
To turn off heat mode, press and hold the power button for 10 seconds to enter heat lock out
mode. Flame lights will flash 6 times to signal the heat function is turned off and locked out. To
turn on heat mode, press and hold the power button for 10 seconds. The flame lights will flash
6 times and the heat function will be restored. When the heat button is pressed in lock out
mode, the ember bed will flash 6 times until the heating mode is turned on.
CARE AND MAINTENANCE
IMPORTANT: Always unplug the power cord before cleaning the unit. Allow the unit to
cool before cleaning it.
• Wipe the exterior surface of the electric firebox occasionally with a soft, damp cloth (not dripping
wet), and dry the exterior surface before operating.
• Do not immerse the electric fireplace in water.
• Do not use any cleaning chemicals such as detergents and abrasives.
• Do not allow the interior to get wet, as this could create a hazard.
• Light accumulated dust may be removed from the electric fireplace with a soft, dry cloth.
• To store the electric fireplace, put it back into its original packaging and store in a clean, dry place.
• The blower and flame motor are pre-lubricated for a durable using time and need no further
lubrication or maintenance. Dust particles will accumulate on/in the electric fireplace, so periodic
cleaning/vacuuming of the electric fireplace is recommended.
• Always turn the heater OFF and unplug the power cord from the outlet before cleaning.
• Cleaning behind the front glass can be done by removing the front glass from the engine assem-
bly. There are two screws on each side of the engine that hold the glass in place. Remove the four
screws that hold the glass and then lift the glass up and away from the engine assembly. While
holding the glass, disconnect the control panel wire harness from the engine assembly. Clean with
a lint free damp cloth. To replace the glass, center the glass over the engine assembly and re-
connect the control panel's wire harness to the engine assembly and lower the glass until it seats.
Install the four screws that you removed into the brackets on each side of the glass. Tighten all the
screws.
Front Glass Removal
Hook
Remove the four screws.
Lift the glass up and
away from the firebox.
Disconnect the control
panel wire harness.
Front Glass Installation
14
Re-connect the control
panel's wire harness.
Lower the glass onto the
firebox.
Install and tighten the
four screws.
Publicidad
