Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Planning Installation
Before you begin assembly, locate the instructions and hardware. Compare all parts with the
Hardware Included and Package Contents lists. Be sure you have all the parts and can identify them.
A helping hand is always good. Assemble your fireplace with an adult assistant if possible.
Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately
5-20 minutes.
Before assembly, use scissors to unwrap the parts from the packaging. Do not use a box cutter or
exacto-knife, as you may cut into the heater pieces inside the box and damage the finish. Check
for the hardware bag located inside the packaging, taped to the top of the box. Do not discard any
pieces. Use an appropriate screwdriver to insert and tighten all screws.
CAUTION: This carton includes a GLASS panel! Always use extreme caution when
handling glass. Failure to do so could result in personal injury or property damage.
Electrical Connection
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock, and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately
call a qualified service technician to inspect the fireplace and replace any part of the
electrical system which has been under water.
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this
appliance. Preferably, the appliance will be on a dedicated circuit, as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse to blow when the fireplace is in operation.
The unit comes standard with a 6 ft (1.8 m) long 3-wire cord, exiting out the back of the fireplace.
Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must
be a minimum No. 14 AWG, 3-wire with grounding type plug and connector, and must be rated not
less than 1875 watts. The extension cord shall not be more than 20 ft (6 m) in length.
Grounding Instructions
This heater is for use with 120 volts. The cord has
a plug as shown at (A) in Figure 1. An adapter as
shown at (C) is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The
green grounding lug extending from the adapter
must be connected to a permanent ground such as
a properly grounded outlet box. The adapter should
not be used if a three-slot grounded receptacle is
available.
NOTE: Adapters are NOT for use in Canada.
1
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
7
A
B
C
Publicidad
