Wireless (Radio) Transmission Mode (Only Lxp-10); Display Backlight; Memory Function; Data Logging Function - Sonel LXP-2 Manual De Uso

4.6

Wireless (radio) transmission mode (only LXP-10)


Connect the OR-1 module to the PC USB socket.

Start „SONEL READER" software.

In order to activate radio transmission function, press SET button and hold it pressed for 2 sec-
onds. Instead of showing the measurement range, the display will show message:

Displaying the measurement range is the same as in USB mode.

To exit the function, again hold SET button pressed for 2 seconds.
Standard PIN code for wireless (radio) transmission is "123".
4.7

Display backlight


Press the backlight button briefly to switch it ON.

Press the backlight button briefly again to switch it OFF.
4.8

Memory function


To save the current data in memory, press ENTER/MEM button and the display will show MEM for
3 seconds along with the cell number in which the measurement will be saved. Each new meas-
urement is saved automatically to the next available cell. When the memory is full, then after
pressing ENTER/MEM, instead of a cell number, the display will show '---' and the measurement
will not be saved.

To read measurement results from the memory - press and hold ENTER/MEM button pressed for
2 seconds. Use
measured value, unit, date and time of measurement (use
memory - main (general) memory or memory of individual functions e.g. Pmax, Pmin, MAX, MIN,
REL. The same data may also be accessed from your PC.

I order to return to the normal operation mode - press and hold ENTER/MEM button for 2 seconds.

To clear the memory, turn the meter ON while holding down ENTER/MEM button. The process of
erasing the memory lasts about 10 seconds. The main display will show
display field will show numbers of cells decreasing to zero, indicting remaining cells to be erased.
After erasing the memory, the meter returns to the measurement mode
4.9

Data Logging function


Set the time and the sampling rate according to par. 2, the default sampling rate is 1 sec.

To start the data logging function, press and hold LOGG button for 2 seconds, the display will
show LOGG and free memory space will be displayed as a percentage value (from 100 to 0). The
memory stores data on measured value, its unit, date and time.

LOGG will blink at intervals equal to the set sampling period, indicating when the measurement is
taken.

When the memory is full, then the percentage value shown is 0 and a double beep is generated to
indicate ending the data logging process. If data logging mode is activated when the meter
memory is full, the meter after 2 seconds will exit this mode and LOGG symbol will disappear - af-
ter that a double beep is generated.

To stop the data logging function, press and hold LOGG button for 2 seconds, the meter will return
to the normal operation mode, data logging may be started from the beginning.

As data is logged in a separate memory, different than a single measurement, the user may save
single measurement results. This may be done by pressing MEM/ENTER button. In such case, the
display apart from LOGG symbol will additionally show MEM, and instead of the percentage value
20
and buttons to scroll individual memory cells. The device will display:
LXP-2 ● LXP-10B ● LXP-10A – USER MANUAL
Note:
and buttons) and information on
and the cell number
.