King Tony 9TYE721AB Manual De Instrucciones página 3

| EN |
WARNING
WARNING
Read all the instruction and warnings first before attempting to operate this jack.
1. DO NOT operate jack on inclined surfaces. Jack must be used on level surfaces only.
Unanticipated motion will occur as soon as jack lifts tire form surface.
2. DO NOT overload jacks beyond the load rating (680kg per unit).
3. DO NOT start the vehicle's engine, or drive with jack in use. Jacks are designed for hand
maneuvering of vehicles only.
4. DO NOT use Jack to lift tires wider than 11 inches.
5.DO NOT attempt to push Jack over obstacles. They are designed to be used on level and
reasonably smooth surfaces only.
6. After lifting, be sure always lock the pin in place before operation. Pull the pin out after
finishing work and then release the valve.
OPERATING INSTRUCTIONS
1.Place the jack on floor and press down on pedal to release pedal lock. Pull out the lock pin
from frame.
2. Before operation,open release valve by turning hand wheel counterclockwise. Expand the
jack by hand-wheel enough to place around tire and position 30 both rollers now contact the
tire tread. To obtain the best control of teh jack while expanding around tire, please your left
hand on top of the left side axle and your right hand at the center of the pedal. Close release
valve by turning hand wheel clockwise to a snug-tight position, the jaack may now be used.
3. Install Jack so that the unit is parallel to the sidewall of the tire to be lifted. Leave
approximately 3/4" of clearance between tire and the jack.This is very important. If unit is
misaligned, it is possible that the tire will be forced to hit the axle of the Jack and not the rollers,
this may damage the Jack and void the warranty.
4.To lift tire, flip directional lever up and place foot on pedal depressing with smooth, even
strokes. Cycle pedal until tire is lifted from surface one inch or less. After lifting,the lower the tire
is to the ground the more stable Jack will be. After lifting,be sure always lock the pin in place
before operating. Repeat process on the other tires and maneuver the vehicle as required.
5.To release Jack,pull the pin out from frame and valve by turning hand wheel counterclockwise
slowly. The jack may be removed when rollers disengage from tire.