cecotec Cumbia POWER MATIC-CCINO Vaporissima Manual De Instrucciones página 25

ENGLISH
Cleaning the ground-coffee outlet
The ground coffee may stick to the outlet wall of the machine after using it for a long time. It is
recommended to clean the outlet frequently by following these steps to ensure the machine
can dispense ground coffee.
1. Press on the cover's bottom part.
2. Remove the side cover.
3. Press the sides of the brewing unit.
4. Remove the brewing unit.
5. Rinse the brewing unit under running tap water. Allow to dry completely.
6. Use the cleaning brush to clean the ground-coffee outlet and remove any remaining
ground coffee or coffee beans from the machine. Fig. 18
7. Use a cloth to clean the inside of the appliance thoroughly. Dry up the appliance
completely before replacing the processing unit and the cover. Fig. 19
6. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
The device does not work. The appliance is not
connected to a mains socket.
When you press a button The device is subject
on the panel repeatedly, to electromagnetic
it does not work or works interference.
with a delay. The control panel is dirty.
Coffee is not hot enough. You have not preheated the
cup or glass.
The brewing unit is too cold.
Coffee does not come out Air is in the coffee machine
and the hot-water button ducts.
flashes.
The first coffee prepared is The grinder's first pass does
of poor quality. not pour enough coffee into
the brewing unit.
POWER MATIC-CCINO VAPORISSIMA
48
POSSIBLE SOLUTIONS
Connect the device and turn
it on.
Check the cord and plug.
Unplug the device. Restart the
device after a few minutes.
Clean the control panel with
a cloth.
Rinse the machine at least 3
times before brewing coffee.
Make sure the water tank is
correctly assembled and filled
up with water.
Press the hot-water button
until the machine dispenses
water from the steam nozzle.
Discard the coffee.
Subsequent coffees will be of
good quality.
The coffee has no foam or The coffee beans are not
is very clear. fresh.
The grinding level is very
coarse.
Buttons do not respond. You are not pressing the
buttons from the front of the
device.
The appliance takes too Too much limescale.
long to warm up.
The water tank has been The water-tank connector's
removed or the water level area is wet.
is very low, but does not
turn on.
The interior drip tray has a There's too-fine ground
lot of water in it. coffee blocking the water
spout.
Coffee is dispensed too There's too-fine ground
slowly or drips. coffee blocking the water
spout.
The empty coffee-bean The interior ground-coffee
tank indicator flashes, but outlet is blocked.
there are still coffee beans
in the coffee-bean tank.
The steam nozzle does not The nozzle is dirty and the
froth milk. hole in the nozzle cover or
the metallic tube is clogged
with milk residue.
7. TECHNICAL SPECIFICATIONS
Product: Power Matic-ccino Vaporissima
Product reference: 01626
Power: 1235-1470 W
Voltage and frequency: 220-240 V, 50-60 Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
ENGLISH
Change the brand of coffee
beans and use a suitable one.
Adjust the grinding level to a
finer one upon operating the
grinder.
Press the lower part of the
button from the front.
Descale the appliance.
Remove the water around the
water-tank connector.
Adjust the coffee grind level
to a coarser level while
operating the grinder.
Adjust the coffee grind level
to a coarser level while
operating the grinder.
Follow the steps in the
"Cleaning and maintenance"
section to clean the outlet.
Follow the steps in the
"Cleaning and maintenance"
section to clean the steam
nozzle.
POWER MATIC-CCINO VAPORISSIMA
49