5. In case of needs, it is possible to regulate the
pressure on the seal by adjusting the eccentric
locking-pins. To do so, remove the anti-fog
lens, then use a flat object with no sharp-
edges to push the locking pins out of the face
shield carefully from the inside; then rotate
them by 180° and reinsert them. Fit the anti-
fog lens and check the seal.
Removal
1. Before starting to remove the antifog lens, first lay the visor on a soft,
clean cloth so that its top edge is facing you.
2. To reduce the pretensioning of the
antifog lens slightly if necessary, use the
balls of your thumbs to carefully bend
the visor sufficiently apart while applying
pressure with your thumbs to release the
anti-fog lens and move it approx. 2–3
mm forward.
3. Now grip the back of the anti-fog lens
with your index and middle fingers and
lift it off the visor. In this position you
can easily remove the anti-fog lens from
the locking pin with your thumb.
4. You can now remove the anti-fog lens
from the visor.
EN
25