Publicidad
Idiomas disponibles
Idiomas disponibles
Use only VITO-approved tools for this machine or
technically identical parts. Not doing so may result in
personal injuries or damages to the sander. In case of
doubt, lack of knowledge or resources, you should
contact an official dealer.
Technical assistance
Your belt sander should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
ASSEMBLY INSTRUCTIONS
Dust collector
1. Fit the dust collector (6) by pushing it all the way in;
2. The dust is extracted directly into the dust collector
through the sanding base plate (8).
3. Pull the dust collector to remove it once again;
For safety reasons, it is essential to use the dust
collector or a dust extraction system.
Connection to a vacuum cleaner/ dust extraction unit
To connect the sander to a vacuum cleaner, you need to
remove the dust collector and place the vacuum
adaptor in its place. Then simply attach the vacuum
cleaner hose to the adaptor.
Installing and changing the sanding belts
Use only sanding belts with the corresponding
dimensions.
Select a sanding belt that suits the material you are
going to work on.
▪ Pull the tension lever (7) to relieve the tension on the
sanding belt. Pull the lever all the way;
▪ Remove the old sanding belt;
▪ Install the new sanding belt. Pay attention to the
arrows which indicate the direction of rotation of the
sanding belt and base plate. The arrows must point in
the same direction;
▪ Set the tension lever to the original position;
After replacing the sanding belt, you have to adjust its
position.
▪ Plug the power cord into a socket and hold the sander
by the two handles (3, 4);
▪ Press the "ON/OFF" switch (11) to switch on the
sander;
▪ Check if the sanding belt is centered. If the sanding
belt isn't aligned, you have to adjust it to the position.
▪ Turn the belt adjustment screw (1) until the sanding
belt is center positioned.
OPERATING INSTRUCTIONS
When working with the belt sander, you should
consider some precautions and operating procedures:
▪ Hold the sander firmly. Loss of control of the sander
can cause serious injury;
▪ When working on loose or small parts, use fixing
devices to secure the parts firmly;
▪ Do not apply excessive pressure to the sander against
the workpiece/object. If speed decreases abruptly,
reduce the pressure on the sander immediately;
▪ Never put down the belt sander before the sanding
base plate (8) has completely stopped;
▪ Wear hearing protection when using the sander
Noise exposure may cause hearing loss;
▪ Switch the belt sander off immediately if any of the
following problems occur:
- Leakage of lubricant through ventilation slots;
- Damage to the sander housing;
- Damage to the "ON/OFF" switch;
- Appearance of smoke or characteristic burning
smell;
Variable speed control dial
The belt sander is equipped with a variable speed
control dial (9), with 6 speed levels.
Level 1: Lower speed;
Level 6: Higher speed;
.
29
Publicidad
