Domo DO7273S Manual De Instrucciones página 39

bag from the dust bag compartment.
4. If at this point you want to clean the motor filter, take
out the filter in its frame by pressing the frame down a
bit. Remove the filter from its plastic frame by pulling
apart the front and back side of the frame at the top.
Clean the filter by rinsing it under warm water. Let the
filter dry completely before reinstalling it. Reinstall the
filter before placing the dust bag into the dust bag compartment.
5. Slide a new dust bag (4 l) in the dust bag frame.
6. Close the dust bag compartment and push the lid back into place. The spring on
the dust bag frame will make sure that the opening of the dust bag is pushed into
the right position when closing the lid.
Cleaning the air filter or HEPA filter
The exhaust air filter or HEPA filter cleans the air a final time before it leaves the
vacuum cleaner. This filter and the grid that covers the filter should be cleaned
regularly. You can clean the filter as follows:
1. Turn off and unplug the vacuum cleaner. Always pull
the plug itself, never pull the cord.
2. Open the grid that covers the filter by lifting up the two
clips on the grid, one by one. The filter is visible when
the grid is removed.
3. Take out the filter.
4. Rinse the filter under cold water and let it dry completely.
5. Put the filter back into place or replace the filter by a new
one. Make sure that the filter is placed properly.
6. Seal with the grid. Make sure that the grid clicks into
place.
39
DO7273S
4