Frigidaire FFGF3054TD Instrucciones De Instalación página 11

30" GAS FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS
12. Adjust air shutter - lower
oven.
To determine if the oven burner flame is proper, remove
the oven bottom panel and lower burner baffle (Refer to
Fig. 19) and set the oven to Bake at 300°F. The approx-
imate flame length of the lower oven burner should be 1
inch with a distinct inner blue flame.
To remove the lower oven bottom, remove oven bottom
hold down screws at rear of oven bottom panel. Pull up
at rear, disengage front of oven bottom from oven front
frame, and pull the oven bottom out of the oven. Remove
lower burner baffle to observe oven burner flame.
If the flame is yellow in color, increase the lower oven air
shutter opening size. If the flame is a distinct blue, reduce
the air shutter opening size.
Lower oven
burner baffle
(removable)
Lower oven
Fig. 19 - oven burner locations
To adjust lower oven air shut-
ter loosen lock screw (See
Fig. 20), reposition air shutter,
and tighten lock screw. When
finished adjusting replace
burner baffle and oven bottom
panel.
Upper oven burner
(some models)
Upper oven burner air
shutter (some models)
Lower oven
bottom panel
(removable)
burner air
shutter
Oven burner
Lock screw
Air shutter
Orifice hood
Fig. 20 - typical oven
burner air shutter
13. Adjust air shutter - upper
oven (some models)
The approximate flame length of the upper (broil) burner
should be 1 inch having a distinct inner, blue flame. To
determine if the upper broil burner flame is proper, set the
oven to Broil. If the flame is yellow, increase upper oven
air shutter opening size. If the flame is a distinct blue,
reduce the air shutter opening size.
To adjust the upper air shutter loosen lock screw (See
Fig. 20), reposition air shutter, and tighten lock screw.
14. Make sure range is level.
Level the range by placing a level horizontally on an oven
rack. Check diagonally from front to back, then level the
range by either adjusting the leveling legs or by placing
shims under the corners of the range as needed.
Note: After installation is complete, make sure all controls
are left in the off position.
11