Fanimation The Edgewood TF910 Serie Manual Del Propietário página 7

WARNING
To avoid possible fire or shock, be sure electricity is
turned off at the main fuse box before hanging.
(Figure 7)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advise, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7' of clearance
from floor to blades. (Figure 8)
1. Securely attach the hanger bracket to the outlet box
using the outlet box screws and washers supplied with
the outlet box. (Figure 9)
WARNING
The outlet box must be securely anchored. Hanger
bracket must seat firmly against outlet box. If the
outlet box is recessed, remove wall board until bracket
contacts box. If bracket and /or outlet box are not
securely attached, the fan could wobble or fall.
2. Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached
to the outlet box. Be sure the groove in the ball is lined
up with tab on the hanger bracket. (Figure 10)
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
How to Hang Your Ceiling Fan
Ceiling
Floor
Figure 8
Hanger
Bracket
Screw (2)
Supplied with
Outlet Box
Figure 9
Hanger
Bracket
Figure 10
7
MAIN FUSE BOX
Figure 7
No
less than
7 ft
Outlet Box
Tab
Outlet Box
Downrod/Hanger
Ball Assembly