Publicidad
Idiomas disponibles
Idiomas disponibles
Important
Before starting any cleaning operation,
always turn off the gas supply tap, cut off the
electricity supply using the master switch and
allow the appliance to cool.
The precautions which follow are also important .
Caution - Warning
When using detergents, rubber gloves, pro-
tective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
– Clean all parts of the appliance with warm wa-
ter, food-approved detergents and non-abra-
sive materials only .
– Thoroughly clean all parts which come into di-
rect or indirect contact with foods and all sur-
rounding areas .
– After use, clean the accessories with a suitable
The appliance has been tested before being put
into service .
The information provided below is intended to
assist in the identification and correction of any
GB
anomalies and malfunctions which might occur
during use .
The user can solve some of these problems himself,
but for others specific technical knowledge or skill
is required, and so they must only be carried out by
qualified staff with recognised experience acquired
in the specific sector of operation .
Fault
The appliance does not
switch on
3326481_ut_GB
CLEANING INSTRUCTIONS
grease-remover product . If possible, wash in
the dishwasher .
Never use products containing substances
harmful or hazardous for health (solvents, pe-
troleum spirits, etc.).
– Rinse surfaces with drinking water and dry .
– Pressurised water jets may only be used on
external parts .
– Take special care not to damage stainless
steel surfaces . In particular, avoid the use of
corrosive products and do not use abrasive
materials or sharp tools .
– Remove food residues immediately before
they set .
– Remove the limescale deposits which may
form on some of the appliance's surfaces .
FAULT
TROUBLESHOOTING
For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Cause
Electrical connection not
made correctly
Power regulator failure
- 10 -
Caution - Warning
Important
Remedy
Check the connection of the
electrical wires .
Contact the after-sales service.
Replace regulator .
Contact the after-sales service.
ENGLISH
Publicidad
