Observe The Following Instructions For The Ed05 Pressure Regulator - Aventics ED05 Instrucciones De Servicio

General instructions
Before assembly
During assembly
AVENTICS | ED05 | R414002533–BAL–001–AG
2.5 Observe the following instructions for the
ED05 pressure regulator
Observe the regulations for accident prevention and
environmental protection for the country where the device is
used and at the workplace.
Do not change or modify the device.
Only use the device within the performance range provided
in the technical data.
Do not place any mechanical loads on the device under any
circumstances. Never use the device as a handle or step. Do
not place any objects on it.
Let the device acclimate itself for several hours before
installation, otherwise water may condense in the housing.
Make sure the relevant system component is not under
pressure or voltage before assembling or when connecting
and disconnecting plugs. Ensure the system cannot be
switched on accidentally. Hang signs on the main switch
that warn workers against switching the system on.
Always assemble the ED05 pressure regulator on a
mounting plate, in a control cabinet, or on a base plate.
Lay the cables so that no one can trip over them.
Only use tested cables. This will rule out the possibility of a
reverse polarization.
53
For your safety