Publicidad
Idiomas disponibles
Idiomas disponibles
English
Worklight (Fig. A)
CAUTION: Do not stare into worklight. Serious eye
injury could result.
The worklight
is activated when the trigger is depressed,
8
and will remain on for a short time after the trigger is
released. If the trigger remains depressed, the worklight will
remain on.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
D
WALT Bluetooth® Tool Tag Ready
e
(Fig. A, J)
Optional Accessory
WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.
WARNING: Remove battery from tool before installing
the D
WALT Bluetooth® Tool Tag.
e
WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your tool comes with mounting holes and fasteners
for installing a D
WALT Bluetooth® Tool Tag (DCE041). You
e
will need a cross head bit tip to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
D
WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D
WALT Tool Connect™ app. For proper installation of
e
the D
WALT Tool Tag, refer to the D
e
To learn more, visit:
www.D
WALT.com/en-us/jobsite-solutions/tool-connect
e
Fig. J
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
10
WALT
e
WALT
e
13
WALT Tool Tag manual.
e
13
Installing and Removing the Battery Pack
(Fig. A, K)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. To charge, insert into the charger as described in the
charger section of this manual.
After removing the battery, squeeze the tool trigger for
three seconds to dissipate the slight electric charge that
may still be in the tool. The worklight may come on for a
brief moment.
Fig. K
Proper Hand Position (Fig. L)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Always hold tool firmly with both hands in the proper
position for operation as shown.
into the tool handle, align the
1
Publicidad
