11 OPTION menu
11.1 RAPID mode
In flash modes A and TTL, the recycling times
depend on how much light is needed for the
exposure. If the recycling time is too long, the
RAPID function can be switched on in the A
and TTL flash modes. The RAPID function is
recommended especially in cases where fast
recycling times are more important and maxi-
mum flash output is less important, such as
in relatively small spaces. However, the gui-
de number is reduced by 1 level, e.g. from a
guide number of 36 (at ISO 100 zoom 35) to
guide number 25 (at ISO 100 zoom 35).
Setting procedure
• Press the
• Press the
OPTION
k
• Press the
O
OPTION
• Press the
RAPID
SUB-REFL.
p
q
• Press the
O
RAPID
OFF
After activation of the RAPID function, „
ON
appears in the display.
192
D
button as often as it takes
for the selection menu to appear.
OPTION
sensor button on the
touch display.
sensor buttons on the
RAPID
touch display and select
RAPID
sensor button on the
touch display.
ON
OFF
or
sensor button on
the touch display and switch the RAPID
function on or off.
The setting is adopted immediately.
OPTION
OPTION
RAPID
SUB-REFL.
ZOOM SIZE
p
q
SUB-REFL. O
.
OFF
1/1
1/2
"
11.2
Secondary reflector (SUB-REFL.)
The secondary reflector is used for frontal
brightening when using a bounce flash if the
main reflector is tilted sideways or upwards.
If the light from the secondary reflector is too
large, it can be reduced by half.
Setting procedure
D
• Press the
button as often as it takes
for the selection menu to appear.
OPTION
• Press the
sensor button on the
touch display.
O
• Press the
sensor buttons on the
touch display and select
SUB-REFL.
• Press the
sensor button on the
touch display.
1/1
1/2
• Press the
,
or
ton on the touch display and switch the
secondary reflector on or off. The setting is
adopted immediately.
Upon switching on the secondary reflector,
appears on the display
„ 1/1" or „ 1/2" is displayed in the INFO
menu.
1/1 means full light output, 1/2 means half
light output.
SUB-REFL.
.
OFF
sensor but-