Mi-T-M GEN-6000-SMH0 Manual Del Usuario página 17

SHUTDOWN
1. Remove all load by turning off electrical appliances and unplugging
electric cords.
2. Allow engine to run no load condition to cool for two (2) minutes.
NOTE: Failure to allow the engine to cool for two (2) minutes may result in
damage to the generator.
3. Close fuel valve on unit or engine.
CONTROLS
CONTROL PANEL:
The generators are equipped with the following items:
GEN-6000-SMH0:
• Circuit Breakers
• Two 125 Volt, 20 Amp, Duplex (2 outlets), GFCI protected
receptacles.
• One 125/250 Volt, 20 Amp, Locking Type Receptacle.
WARNING: NEVER
RECEPTACLE. THESE RECEPTACLES ARE PROTECTED
AGAINST OVERLOADS BY RESETTING MAGNETIC
TYPE CIRCUIT BREAKERS. IF A CIRCUIT BREAKER
TRIPS, THE CAUSE SHOULD BE DETERMINED AND
CORRECTED PRIOR TO CONTINUING USE.
CONTROLS
OIL WARNING DEVICE:
NOTE: This engine is equipped with a "Low Oil" shutdown system for engine
protection. The engine stops when the oil level gets too low. The engine
will not restart without adding oil. If the unit is tilted too much during
operation, it may suddenly stop even though the oil level is not low.
Check the engine oil before restarting the engine. If the unit is tilted,
level the engine, then check the oil before restarting the engine.
Operator's Manual
OPERATING THE GENERATOR
EXCEED THE RATING OF A
17