Mi-T-M GEN-6000-SMH0 Manual Del Usuario página 22

AIR CLEANER:
WARNING: RISK OF FIRE OR EXPLOSION. DO NOT
USE GASOLINE OR LOW FLASH-POINT SOLVENTS
TO CLEAN THE ELEMENT. CLEAN THE ELEMENT
IN A WELL VENTILATED AREA. ENSURE THAT NO
SPARKS OR FLAMES ARE NEAR THE WORKING
AREA, THIS INCLUDES ANY APPLIANCE WITH A
PILOT LIGHT.
CAUTION: NEVER RUN THE ENGINE WITHOUT THE
AIR FILTER, SERIOUS DANGER CAN RESULT.
Check the air cleaner daily or before starting the engine. Check
for and correct heavy buildup of dirt and debris along with
loose or damaged components. (See Fig. 8)
1. Unsnap the air cleaner cover and remove the elements.
2. Clean the elements:
FOAM PRE-CLEANER ELEMENT: Wash the foam pre-cleaner
element in warm water with detergent. Rinse the foam pre-
cleaner element thoroughly until all traces of detergent are
eliminated. Squeeze out excess water, but do not wring. Allow
the foam pre-cleaner element to air dry.
Saturate the foam pre-cleaner element with new engine oil.
Squeeze out all excess oil. DO NOT put engine oil on the foam
damper.
NOTE: Clean the foam pre-cleaner element every 25 hours of operation
(more often under extremely dusty or dirty condition)
PAPER AIR CLEANER ELEMENT: Do not wash the paper ele-
ment or use pressurized air, as this will damage the element.
Clean by gently tapping the element to remove dust. Replace
the element if damaged, bent or extremely dirty. Handle new
element carefully; do not use if the sealing surfaces are bent or
damaged.
NOTE: Replace the paper element every 100 hours (more often under
extremely dusty conditions.)
3. Reinstall the foam pre-cleaner element and the paper air
cleaner element. Close air cleaner cover and clasp shut.
CLEANING AND GAPPING SPARK PLUG:
If the plug is contaminated with carbon, remove it using a plug
cleaner or wire brush.
Check the spark plug gap and reset it if necessary. The spark
plug gaps are listed below. To change the gap, bend the side-
electrode only, using a spark plug tool. (Fig. 9)
Install and tighten the spark plug. Connect the spark plug lead.
Recommended Spark Plug:
ENGINE
SPARK PLUG
SPARK PLUG GAP
TORQUE - NEW
TORQUE - RETIGHTEN
22
SERVICE
MI-T-M
NGK BPR6ES
0.7 - 0.8 mm
(0.03 in.)
8.7-10.9 ft-lb
16.6-19.5 ft-lb
(Fig. 8)
Spark Plug Gap
(See recommendations)
(Fig. 9)
Operator's Manual