How To Use - Hitachi Koki WM 10DBL Instrucciones De Manejo

3. Installing the bit
Driver bit
Always follow the following procedure to install driver
bit. (Fig. 4)
(1) Pull the guide sleeve back.
(2) Insert the bit into the hexagonal hole in the anvil.
(3) Release the guide sleeve and it returns to its original
position.
CAUTION:
If the guide sleeve does not return to its original
position, then the bit is not installed properly.
Drill bit
• A drill with hexagonal shank can be attached directly
to the tool.
• To attach a drill without hexagonal shank, you need
to have the drill chuck adapter set sold separately.
(1) Insert the drill bit into the chuck.
(2) Use the chuck key to secure the drill bit, tightening
the chuck by each of the three holes in turn. (Fig. 5)
• Use an iron drill to make a pilot hole for a wood
screw or a 10 mm or smaller hole.
(1) Insert the drill bit into the chuck.
(2) Use the chuck key to secure the drill bit, tightening
the chuck by each of the three holes in turn. (Fig. 5)

HOW TO USE

How to make the batteries perform longer
Recharge the batteries before they become completely
exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery.
If you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
1. Mode selection and rewriting functions
The operation mode is switched each time you press
the mode selection switch provided on the side of the
tool body.
Select an operation mode corresponding to your
desired operation (Fig. 6).
NOTE:
The mode selection can be switched only after
installing the charger to the body and once pulling
the switch.
(1) Default setting for operation mode
The following four modes are set as default operation
mode on this machine.
Symbol Operation mode
A Electronic pulse "3" Tightening of wood screws
B Bolt "Continuous" Tightening of bolts
C Self drilling screw "2" Tightening of self drilling screw
D Drill
NOTE:
The tightening torque obtained in an actual tightening
operation varies with the screw or clamping member
used.
Try to tighten a few screws to confirm the appropriate
tightening torque.
Use the Bolt mode to tighten bolts.
Mode switching is impossible if the mode selection
switch is operated with the switch turned on. Be sure
to turn off the switch before performing mode
switching.
(2) Built-in operation modes and mode rewriting
function of this product
The machine includes 20 operation modes in total.
The setting of each mode is described below.
You can freely select up to four operation modes by
using an optional communication adaptor. It is also
possible to limit the number of switchable modes to
one or two, or to set all of the four modes to a same
operation mode.
English
Example of applicable operation
Drilling
10