Publicidad
Idiomas disponibles
Idiomas disponibles
D
WALT Bluetooth® Tool Tag Ready (Fig. F)
e
Optional Accessory
WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.
WARNING: Remove battery from tool before installing
the D
WALT Bluetooth® Tool Tag.
e
WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your tool comes with mounting holes
for installing a D
WALT Bluetooth® Tool Tag (DCE041). You
e
will need a T15 torx bit tip to install the tag. Screw torque
should be between 0.8 and 1.2 Nm (7.1 to 10.6 in-lbs). The
D
WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D
WALT Tool Connect™ app. For proper installation of
e
the D
WALT Tool Tag, refer to the D
e
To learn more, visit:
www.D
WALT.com/en-us/jobsite-solutions/tool-connect
e
Fig. F
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Installing and Removing the Battery Pack
(Fig. E)
WARNING: Ensure the tool/appliance is in the off
position before inserting the battery pack.
nOTE: For best results, make sure your battery pack is
fully charged.
1. To install the battery pack
align the battery pack with the rails inside the tool's
handle and slide it into the handle until the battery
pack is firmly seated in the tool and ensure that it does
not disengage.
2. To remove the battery pack from the tool, press the
battery pack release button
WALT
e
WALT
e
12
and fasteners
WALT Tool Tag manual.
e
15
1
into the tool handle,
2
and firmly pull the
battery pack out of the tool handle. Insert it into
the charger as described in the charger section of
this manual.
Fig. G
15
Proper Hand Position (Fig. H)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
, with the other hand on the top handle
3
Fig. H
Drilling
WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly. If drilling thin material, use a wood
"back‑up" block to prevent damage to the material.
1. Use sharp drill bits only. For WOOD, use twist drill
bits, spade bits, auger bits, self-feed bits, or hole saws.
For METAL, use steel twist drill bits or hole saws. For
CONCRETE, use dry core bits. Do not use water.
2. Always apply pressure in a straight line with the bit. Use
enough pressure to keep drill biting, but do not push
hard enough to stall the motor or deflect the bit.
2
English
1
.
4
9
Publicidad
